A fan profile can be selected from the BMC web GUI and customisation is done through the command line using ipmitool on the NAS console or ipmiutil for remote administration. I have already set up IMPI fan control for my NAS (TrueNAS Core), based on Supermicro (server) motherboard. You actually have to plug the BMC to a LAN and power it up to learn how you should have wired the fans in your case… What fun! Frustrating: It's all in the GUI-and there is not much! Making matter worse Gigabyte's excuse for a documentation is a mere string of screenshots without any explanation. The issue seems to be in the way OS X installers operate rather than with my settings.Īs for fan control it was both very simple, and also frustrating. In swiching to OpenCore 0.6.6 I used another USB stick which had a Mojave installer and found that, contrary to Catalina, I could boot this one and get to the installer GUI-but then it would fail after the reboot. The last few days have been frustrating: Although I can set the boot drive or create persisting entries in NVRAM, I still cannot run an OS X installer or updater. This point can be interesting for ASUS WS C422Pro/SE users because this motherboard has cooling monitor and control via BMC chip (IPhone show up as a USB 3.0 device on the USB 3.0 bus even if it's connected to a thunderbolt 3 port on a original Mac.) Is your iPhone showing up if you connect it to your ASM2142 port with a lightning cable? If so it must have to be something with your flashed Titan Ridge firmware. You need to investigate that a little bit further. I've read somewhere that all devices is not showing up with flashed cards depending on which firmware you flashed. Is your Titan Ridge card flashed? If so I think this could be the culprit. The same in Hackintool,both disk:s shows up with correct speed too. Smc fan control mojave mac#I have no USB-C to Lightning cable so I can't test that but if I put one of my external USB-C disk in one of my thunderbolt port:s and the other one in my ASM2142 port:s I have this result in About this Mac -> System Report -> USB. But when USB-C drives, iPhone with USB-C to Lightning cable and the iPad with USB-C to lighting cable is plugged into the USB-C/Thunderbolt port it charges but nothing shows up on the USB tree and it is not detected by the system. Yes, the USB tree shows up and is completely as it should.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |